Do You Need A Ballast For Led Tubes

To have them at their most efficient a ballast bypass is required how to convert 4ft fluorescent light to led.

Do you need a ballast for led tubes. Also the leds typically use direct current dc and thus need an ac to dc converter. You do not need a ballast for led lights but instead a driver. I hope this helps. This surge can damage or even kill an led tube.

Verde often uses this approach to replace t12 magnetic ballasts as well as older t8 systems with aging electronic ballasts. In other words they have different wiring methods. Leds use a technology that s similar to a ballast called a driver. No ballast maintenance removing the ballast simplifies the number of fixture components that need to be maintained.

Ballast bypass led tube type b pros. This is called ballast factor. A ballast bypass is a common procedure to remove the ballast from the existing fixture. Less energy used through elimination of ballast draw an extra couple of watts is consumed when you pair an led lamp with a ballast.

No you do not need a ballast with led lights to regulate current. Additionally all ballasts will fail over time and when they do you ll have to climb back up into your fixtures remove all your ballast compatible led tubes cut the power to the dead ballasts install a new ballast and put all your tubes back up. Reinaldo philips instantfit led tubes are ballast dependent which means you must use the ballast. This is why when retrofitting to led corn light bulbs you need to direct wire the socket.

Like a ballast a driver regulates the electricity within a lighting fixture to keep the current consistent. You might be thinking i just used an led and didn t install a driver. Led s require less energy and can be sensitive to excess energy. This is required for most retrofit installations of our dual ended and single ended tubes as fluorescent replacements except for our plug and play tubes.

Leds don t need a ballast because of a number of reasons. They are meant to be a plug and play option meaning you take the fluorescent out and put in the led bulb without any re wiring involved. Led technology does not require a ballast to regulate the amount of energy flowing to the lights. This is called a type c application with a tube and driver that work together.

Since you re bypassing the ballast the wattage on the lamp is the wattage consumed. First large amounts of current aren t needed in led bulbs. The circuit structure of the led tube lightrequires rewiring the fixture in a practice to replacethe fluorescent which willbe very expensive.